|
Member Review - Rudel Gurken : 30-Sep-2007 20:35 |
|
|
0 out of 0 users (0.00%) have found this review useful
|
|
|
| Rating: |
4.00 |
| Comment: |
Standard engine, CASE and ECM make this mech hard to take down despite not being fully armored.
The upgraded main weapon and the LRM can make good use of the C3i and the pulse laser is much more useful than the former small lasers. The SRM had to be dropped to fit the electronics in but as this Wyvern is more of a long-range sniper that isn't much of a problem. |
| No topic has been started for this review [Start Topic] |
|
|
|
|
|
Member Review - Blackhand : 17-Sep-2004 00:00 |
|
|
0 out of 0 users (0.00%) have found this review useful
|
|
|
| Rating: |
4.00 |
| Comment: |
This mech gives up a lot to get its C3I but considering what the rest of some of the C3i upgrades look like. This is above average.
I'd argue its a bit slow and low armoured but the standard engine and lack of real large amounts of ammo means it will survive suprisingly long. |
| No topic has been started for this review [Start Topic] |
|
|
|
|
|
Member Review - DarkAdder : 18-Jan-2004 00:00 |
|
|
0 out of 0 users (0.00%) have found this review useful
|
|
|
| Rating: |
3.50 |
| Comment: |
Ive notice that each mech modified for a C3 or C3i unit has had to remove some important piece of weaponry or equipment. And this mechproves my point. The mech gives up the SRM launcher for the C3i and the ECM gear. This forces the mech to use the ER PPC at a closer range than was intended meaning a forced heat spike. |
| No topic has been started for this review [Start Topic] |
|
|
|
|
Double Heat Sink 5. Sensors 5.
Double Heat Sink 6. Life Support 6.
Double Heat Sink 1.
Write Review